Will Autel IM608 with XP400 Pro Write a Key to an EWS3?

Question

Has anyone tried writing a key to an EWS3 module using the Autel IM608 + XP400 Pro adapter? I bought the EEPROM expansion pack specifically to bench EWS modules but the adapter provided for the 0D46J doesn’t fit due to the lack of clearance with a relay on the board. Am I missing something here?

Suggestion

I think what happened is you just went by chip, you need to go make key by dump. The XP400 Pro adapter in the KPA set appears to just plug in and read, no need to clamp directly over the MCU.

Solved!

You’re correct. I eventually played around with it last night and it kept saying I was uploading the incorrect size bin file so I gave up out of frustration. I just sat down and repeated my steps, saved a new bin, then uploaded to perform the write via dump and finally succeeded. Thanks for the help! My dumbass was uploading the wrong bin the entire time.

Update:

Confirmed! Thanks, everyone for the help!

Thanks to Wesley Main & Thomas Martin for the question.